Printer Installation

  1. Plug in the Printer either via USB or over the Network
    1. USB connection: Plug the printer cable into the PC.
    2. Network connection: On the actual printer. Find the IP address assigned:

      1. Select 'Menu'
      2. Admin Menu
      3. Network Setup
      4. TCP/IP
      5. IPv4
      6. IP Address
      7. Note down the IP address
  2. Now, on the computer, navigate to the 'Control Panel' and click on 'Devices and Printers'
  3. Select 'Add a Printer'
  4. Then select ‘The printer that I want isn’t listed’
    1. USB connection:
      1. Select ‘Add a local printer or network printer with manual settings
      2. Select a Virtual printer port for USB
    2. Network connection:
      1. Select ‘Add a printer using a TCP/IP address or hostname’
      2. Enter the IP address found above
  5. Click ‘Have Disk’
  6. Browse to C:\golfautoscore\Printer Driver\x64\FX6ZAAL.inf’and select ok
  7. Select the ‘FX DocuPrint P355 d PCL 6’ printer and then click next.
  8. Replace the current driver
  9. Right click on the Printer installed and select Printing Preferences
  10. Set the Paper size to A5.
  11. Set the Paper type to Heavyweight Cardstock.
  12. Select the ‘Image Options’ tab and set the Margins to Standard and Print position to Center.
  13. Select ok.
  14. Select ok.
  1. On the actual printer:
    1. Power settings: Menu –Admin Menu – System Settings – Power Saver Time – Sleep Timer – Set to 60 minutes
    2. Sound: Menu –Admin Menu – System Settings – Audio Tones – All tones - Off
    3. Fusion: Menu – Admin Menu – Maintenance Mode – Adjust Fusing Unit – Heavy Card – Set to 3
    4. Card Type: Menu – Tray Settings – Tray 1 - Paper Type – Set to Heavy Card
    5. Card Size: Tray Settings – Tray 1 - Paper Size – Set to A5
  2. Restart the computer
  3. Place the scorecards into the tray as described in the picture below.
  4. Place a description of how to place the scorecards into the printer.
  5. Test a card print (If no card is printed then restart the computer again).

Select ok.